Network Working Group K. Zeilenga Request for Comments: 4528 OpenLDAP Foundation Category: Standards Track June 2006 Lightweight Directory Access Protocol (LDAP) Assertion Control Status of This Memo This document specifies an Internet standards track protocol for the Internet community, and requests discussion and suggestions for improvements. Please refer to the current edition of the "Internet Official Protocol Standards" (STD 1) for the standardization state and status of this protocol. Distribution of this memo is unlimited. Copyright Notice Copyright (C) The Internet Society (2006). Abstract This document defines the Lightweight Directory Access Protocol (LDAP) Assertion Control, which allows a client to specify that a directory operation should only be processed if an assertion applied to the target entry of the operation is true. It can be used to construct "test and set", "test and clear", and other conditional operations. Table of Contents 1. Overview ........................................................2 2. Terminology .....................................................2 3. The Assertion Control ...........................................2 4. Security Considerations .........................................3 5. IANA Considerations .............................................4 5.1. Object Identifier ..........................................4 5.2. LDAP Protocol Mechanism ....................................4 5.3. LDAP Result Code ...........................................4 6. Acknowledgements ................................................5 7. References ......................................................5 7.1. Normative References .......................................5 7.2. Informative References .....................................5 Zeilenga Standards Track [Page 1] RFC 4528 LDAP Assertion Control June 2006 1. Overview This document defines the Lightweight Directory Access Protocol (LDAP) [RFC4510] assertion control. The assertion control allows the client to specify a condition that must be true for the operation to be processed normally. Otherwise, the operation is not performed. For instance, the control can be used with the Modify operation [RFC4511] to perform atomic "test and set" and "test and clear" operations. The control may be attached to any update operation to support conditional addition, deletion, modification, and renaming of the target object. The asserted condition is evaluated as an integral part the operation. The control may also be used with the search operation. Here, the assertion is applied to the base object of the search before searching for objects that match the search scope and filter. The control may also be used with the compare operation. Here, it extends the compare operation to allow a more complex assertion. 2. Terminology Protocol elements are described using ASN.1 [X.680] with implicit tags. The term "BER-encoded" means the element is to be encoded using the Basic Encoding Rules [X.690] under the restrictions detailed in Section 5.1 of [RFC4511]. DSA stands for Directory System Agent (or server). DSE stands for DSA-specific Entry. In this document, the key words "MUST", "MUST NOT", "REQUIRED", "SHALL", "SHALL NOT", "SHOULD", "SHOULD NOT", "RECOMMENDED", "MAY", and "OPTIONAL" are to be interpreted as described in BCP 14 [RFC2119]. 3. The Assertion Control The assertion control is an LDAP Control [RFC4511] whose controlType is 1.3.6.1.1.12 and whose controlValue is a BER-encoded Filter [Protocol, Section 4.5.1]. The criticality may be TRUE or FALSE. There is no corresponding response control. The control is appropriate for both LDAP interrogation and update operations [RFC4511], including Add, Compare, Delete, Modify, ModifyDN (rename), and Search. It is inappropriate for Abandon, Bind, Unbind, and StartTLS operations. Zeilenga Standards Track [Page 2] RFC 4528 LDAP Assertion Control June 2006 When the control is attached to an LDAP request, the processing of the request is conditional on the evaluation of the Filter as applied against the target of the operation. If the Filter evaluates to TRUE, then the request is processed normally. If the Filter evaluates to FALSE or Undefined, then assertionFailed (122) resultCode is returned, and no further processing is performed. For Add, Compare, and ModifyDN operations, the target is indicated by the entry field in the request. For Modify operations, the target is indicated by the object field. For Delete operations, the target is indicated by the DelRequest type. For Compare operations and all update operations, the evaluation of the assertion MUST be performed as an integral part of the operation. That is, the evaluation of the assertion and the normal processing of the operation SHALL be done as one atomic action. For Search operations, the target is indicated by the baseObject field, and the evaluation is done after "finding" but before "searching" [RFC4511]. Hence, no entries or continuations references are returned if the assertion fails. Servers implementing this technical specification SHOULD publish the object identifier 1.3.6.1.1.12 as a value of the 'supportedControl' attribute [RFC4512] in their root DSE. A server MAY choose to advertise this extension only when the client is authorized to use it. Other documents may specify how this control applies to other LDAP operations. In doing so, they must state how the target entry is determined. 4. Security Considerations The filter may, like other components of the request, contain sensitive information. When it does, this information should be appropriately protected. As with any general assertion mechanism, the mechanism can be used to determine directory content. Hence, this mechanism SHOULD be subject to appropriate access controls. Some assertions may be very complex, requiring significant time and resources to evaluate. Hence, this mechanism SHOULD be subject to appropriate administrative controls. Zeilenga Standards Track [Page 3] RFC 4528 LDAP Assertion Control June 2006 Security considerations for the base operations [RFC4511] extended by this control, as well as general LDAP security considerations [RFC4510], generally apply to implementation and use of this extension. 5. IANA Considerations 5.1. Object Identifier The IANA has assigned an LDAP Object Identifier [RFC4520] to identify the LDAP Assertion Control defined in this document. Subject: Request for LDAP Object Identifier Registration Person & email address to contact for further information: Kurt Zeilenga Specification: RFC 4528 Author/Change Controller: IESG Comments: Identifies the LDAP Assertion Control 5.2. LDAP Protocol Mechanism Registration of this protocol mechanism [RFC4520] is requested. Subject: Request for LDAP Protocol Mechanism Registration Object Identifier: 1.3.6.1.1.12 Description: Assertion Control Person & email address to contact for further information: Kurt Zeilenga Usage: Control Specification: RFC 4528 Author/Change Controller: IESG Comments: none 5.3. LDAP Result Code The IANA has assigned an LDAP Result Code [RFC4520] called 'assertionFailed' (122). Subject: LDAP Result Code Registration Person & email address to contact for further information: Kurt Zeilenga Result Code Name: assertionFailed Specification: RFC 4528 Author/Change Controller: IESG Comments: none Zeilenga Standards Track [Page 4] RFC 4528 LDAP Assertion Control June 2006 6. Acknowledgements The assertion control concept is attributed to Morteza Ansari. 7. References 7.1. Normative References [RFC2119] Bradner, S., "Key words for use in RFCs to Indicate Requirement Levels", BCP 14, RFC 2119, March 1997. [RFC4510] Zeilenga, K., Ed., "Lightweight Directory Access Protocol (LDAP): Technical Specification Road Map", RFC 4510, June 2006. [RFC4511] Sermersheim, J., Ed., "Lightweight Directory Access Protocol (LDAP): The Protocol", RFC 4511, June 2006. [RFC4512] Zeilenga, K., "Lightweight Directory Access Protocol (LDAP): Directory Information Models", RFC 4512, June 2006. [X.680] International Telecommunication Union - Telecommunication Standardization Sector, "Abstract Syntax Notation One (ASN.1) - Specification of Basic Notation", X.680(2002) (also ISO/IEC 8824-1:2002). [X.690] International Telecommunication Union - Telecommunication Standardization Sector, "Specification of ASN.1 encoding rules: Basic Encoding Rules (BER), Canonical Encoding Rules (CER), and Distinguished Encoding Rules (DER)", X.690(2002) (also ISO/IEC 8825-1:2002). 7.2. Informative References [RFC4520] Zeilenga, K., "Internet Assigned Numbers Authority (IANA) Considerations for the Lightweight Directory Access Protocol (LDAP)", BCP 64, RFC 4520, June 2006. Author's Address Kurt D. Zeilenga OpenLDAP Foundation EMail: Kurt@OpenLDAP.org Zeilenga Standards Track [Page 5] RFC 4528 LDAP Assertion Control June 2006 Full Copyright Statement Copyright (C) The Internet Society (2006). This document is subject to the rights, licenses and restrictions contained in BCP 78, and except as set forth therein, the authors retain all their rights. This document and the information contained herein are provided on an "AS IS" basis and THE CONTRIBUTOR, THE ORGANIZATION HE/SHE REPRESENTS OR IS SPONSORED BY (IF ANY), THE INTERNET SOCIETY AND THE INTERNET ENGINEERING TASK FORCE DISCLAIM ALL WARRANTIES, EXPRESS OR IMPLIED, INCLUDING BUT NOT LIMITED TO ANY WARRANTY THAT THE USE OF THE INFORMATION HEREIN WILL NOT INFRINGE ANY RIGHTS OR ANY IMPLIED WARRANTIES OF MERCHANTABILITY OR FITNESS FOR A PARTICULAR PURPOSE. Intellectual Property The IETF takes no position regarding the validity or scope of any Intellectual Property Rights or other rights that might be claimed to pertain to the implementation or use of the technology described in this document or the extent to which any license under such rights might or might not be available; nor does it represent that it has made any independent effort to identify any such rights. Information on the procedures with respect to rights in RFC documents can be found in BCP 78 and BCP 79. Copies of IPR disclosures made to the IETF Secretariat and any assurances of licenses to be made available, or the result of an attempt made to obtain a general license or permission for the use of such proprietary rights by implementers or users of this specification can be obtained from the IETF on-line IPR repository at http://www.ietf.org/ipr. The IETF invites any interested party to bring to its attention any copyrights, patents or patent applications, or other proprietary rights that may cover technology that may be required to implement this standard. Please address the information to the IETF at ietf-ipr@ietf.org. Acknowledgement Funding for the RFC Editor function is provided by the IETF Administrative Support Activity (IASA). Zeilenga Standards Track [Page 6]